0

I'm using x32dbg and I've set a hardware memory breakpoint. It triggers successfully for a specified module and the debugger pauses and a message on the bottom says:

Hardware breakpoint (byte, read/write) at mscorlib.ni.69`9d3d9 (6919d3d9)!

All good so far. Now naturally I want to go to address 6919d3d9, which I assume to be the starting memory address of the code that accessed my target memory location.

So I go to Breakpoints view (Alt+B) double click on the breakpoint and it gets me to Dump, ie the memory view.. This is where I'm confused. I can't find out how to go to address 6919D3D9 to see the disassembled instructions. Kindly help if you can.

0

Normally the debugger should pause at the location where breakpoint is triggered, or you can use "jump to EIP" or similar command to navigate to the instruction being executed (which should be the one that triggered the exception).

| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.