2

Recently IDA started to synchronize the hex dump with disassembly view. Even if I disable this through right click, it gets reseted every debug session. I also tried to save the desktop with the synchronization disabled, but it gets enabled again after session restart...

How can I stop IDA from synchronizing these views?

I have no plugins that could cause this behavior.

3
  • Which version of IDA are you using? Just checked it on IDA 6.8 on Windows and it did not reproduce.
    – tmr232
    Sep 13, 2015 at 21:38
  • 6.6, Windows virtual machine on Linux host.
    – rr-
    Sep 13, 2015 at 21:47
  • You can play with ./cfg/ida.cfg ... Try replace ./cfg/ida.cfg with default config.
    – DOD
    Sep 14, 2015 at 9:03

1 Answer 1

1

In IDA 7.3 you can just close and reopen the hex view (or IDA view). This causes the hex view to stop synchronizing to the address of the disassembly.

Revert and synchronize using Windows->Reset desktop.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Not the answer you're looking for? Browse other questions tagged or ask your own question.